Rockers

Rockers	Counters	Loops
1. Edge too deep, too soon; An improper edge was taken before assuming the correct edge; A change of edge after the turn (Three turn)	1. Change of edge before the turn (actually a three turn)	1. Circle loop: not long enough: too wide for its length
2. Change of edge before turn	2. Sub-curve before Counter	2. Pointed Loop
3. Sub-curve after Rocker	3. Turn off axis	3. Cutting off bottom of Loop
4. Sub-curve before Rocker	4. Sub-curve after Counter	4. Sub-curve after Loop
5. Long flat after turn	5. Long flat on entrance side of counter, another common error	5. Sub-curve before Loop
6. Long flat before turn	6. Long flat on exit side of Counter	6. Cutting off exit side of Loop
7. Flat Rocker: flats on both sides of the Turn	7. Flat turn	7.Exit of Loop too full
8. Late off axis turn		8. Cutting off entrance side of Loop
		9.Entrance of Loop to full